more details sbc in place of lt1

[Hotrodderzzz at aol.com]

More detail in my previous question of sbc in place of lt1:
Car is a 1995 9C1 Caprice, no collector value, I already have a stout 406 sbc 
(Chevy High Performance article build up, Iron Eagle heads, 6" rods, KB 
pistons, stock crank)  lt1 needs rebuilding.
I was contemplating using the stock 4l60e and pcm, maf, wiring, etc. (with 
mini-ram) thinking that the only input missing would be the optispark signal 
(a regular hei distributer fits with a little trimming of the base, and I was 
planning on using a stock computer distributor or a crank fired msd or 
similar setup) but I confess that at this time i do not know if the tps and 
other sensors are the same.  Brackets and cables I can handle, I was hoping 
to use the stock pcm with lt1 edit for the computer.
Thanks again for input and any additional input on this matter.  SKip
 
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org