more details sbc in place of lt1

[Bruce Plecan]

LT1 PCM doesn't have a clue about using a Distributor.
Grumpy


> More detail in my previous question of sbc in place of lt1:
> Car is a 1995 9C1 Caprice, no collector value, I already have a stout 406
sbc
> (Chevy High Performance article build up, Iron Eagle heads, 6" rods, KB
> pistons, stock crank)  lt1 needs rebuilding.
> I was contemplating using the stock 4l60e and pcm, maf, wiring, etc. (with
> mini-ram) thinking that the only input missing would be the optispark
signal
> (a regular hei distributer fits with a little trimming of the base, and I
was
> planning on using a stock computer distributor or a crank fired msd or
> similar setup) but I confess that at this time i do not know if the tps
and
> other sensors are the same.  Brackets and cables I can handle, I was
hoping
> to use the stock pcm with lt1 edit for the computer.
> Thanks again for input and any additional input on this matter.  SKip
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org