730 speed sensor

[Daniel]

Thanks Bob
Do they both wire up to pin B9 and B10 ?
What BCC is the magnetic for a 350 ?

Daniel Collins
bossute at iprimus.com.au

----- Original Message -----
From: "Bob Valentine" <bob at tecmark.com>
To: <gmecm at diy-efi.org>
Sent: Sunday, July 08, 2001 3:08 PM
Subject: Re: 730 speed sensor


> The stock setup used either a 4000ppm (4 pulse/rev) magnetic or 2000ppm (2
> pulse/rev) optical VSS.  Calibration determines which is used.
>
> -> Bob Valentine
> -> bob at tecmark.com
>
> At 02:38 PM 7/8/2000 +0800, you wrote:
> >I am trying to find out how many pulses/rev the 730 ecm requires and if
it
> >is a magnetic sensor or a hall effect type ?
> >The truck has been converted when it came into Australia but no one
bothered
> >to fit a VSS adapter so TCC doesn't work and the idles not real good on
> >deceleration.
> >I can get a 8 pulse magnetic inline VSS but wasn't sure what the 730
> >requires
> >
> >Daniel
> >
>
>---------------------------------------------------------------------------
-
> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> >in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> >
> >
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org