A few lt1 ?'s

[Mike]

Its a 96 with a 4l60-e. the manual says the wire is a switched 12v. its a
purple wire ,if that even matters to you :). it would seem like there should
be a wire from the breaks to the pcm for the tcc unlock right?

mike
----- Original Message -----
From: <Chipsbyal at aol.com>
To: <gmecm at diy-efi.org>
Sent: Saturday, May 13, 2000 2:44 PM
Subject: Re: A few lt1 ?'s


> I thought this was a 96 application. If so there isn't a 4th gear pressure
> switch. Be sure you have a non-electric shift 700R4 before pulling the
pan.
> It has the wiring on the drivers side. The 4L60-E has the main harness
> connector on the passenger side.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org