730 ECM Swap

[Bruce Plecan]

Some would say a 165 needs shot.. <g>
Any C-3 would work as far as I know,
Bruce



----- Original Message -----
From: "Romans, Mark" <romans at starstream.net>
To: <gmecm at diy-efi.org>
Sent: Monday, November 06, 2000 11:16 PM
Subject: Re: 730 ECM Swap


> I have purchased several 730's from Pick-N-Pull and I ALWAYS
> cut the harness about a foot (Or farther) from the connectors and
> leave the connectors in the ecm.  All have been for $32.00 complete with
> pigtails!  I just hate to kill a 165 ecm to get the other end.
> Mark
> ----- Original Message -----
> From: <WEG1192 at aol.com>
> To: <gmecm at diy-efi.org>
> Sent: Monday, November 06, 2000 7:01 PM
> Subject: Re: 730 ECM Swap
>
>
> > My take on this so far. You would only need to solder the junkyard wires
> at
> > the back of the 165 header, and not have to remove any pins from the
7730
> > connectors. If you go the brand new route, you'll have to solder the
> > terminals to all 7730 wires, insert them into the 7730, and then solder
> the
> > wires to the back of the 165 header. So maybe a junkyard 7730 harness is
> the
> > way to go after all to save time. My quote from Pioneer Standard says
> there
> > is a minimum order charge of $25, but if you can get them yourself, I
> guess
> > that is the way to go. I was volunteering so I could get them all over
the
> > $25 min order. Sounds like a group buy has become a bunch of individual
> buys.
> > As for making a profit from the list buy, I was going to show my cost so
> no I
> > was not intending to make a profit from the list. HOWEVER, I did think
of
> > selling my version of the harness on Ebay or my site for a modest labor
> and
> > parts charge, so I guess I'll bow out.  JW
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org