DIS Ditty

[Bruce Plecan]

Yep from the syn signal till TDC, so I would have thought saying it was 60
degrees away it would allow me to retard the timing 10d
Bruce



> isn't the 70 to 60 figure BTDC?
>
> Swayze
> mswayze at truswood.com
> kswayze at bellsouth.net
>
> ----- Original Message -----
> From: <JTesta1966 at aol.com>
> To: <gmecm at diy-efi.org>
> Sent: Monday, November 13, 2000 4:35 PM
> Subject: Re: DIS Ditty
>
>
> > In a message dated 11/13/00 3:39:22 PM Eastern Standard Time,
> > nacelp at bright.net writes:
> >
> > << If some one sees the error in changing the reference angle from 70 to
> 60,
> >  and then adding 10d to the base spark table please let me know. >>
> >
> > Why would you do that Bruce? So it starts easy but you can run lots is
> > initial advance?
> >
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > Jim  (FA) Testa                                             TType86 on
> > #BuickGN
> > ASE Master Technician
> buick.fiendish.net:6667
> > L1 Advanced Engine Performance                    NJ Lic MV Inspector
> > jtesta1966 at aol.com                           NJ Lic Emission Repair Tech
> > http://members.aol.com/jtesta1966/buick.htm
> > Associate Sponsor, Buicks at Bristol (RCA/JTP)
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org