Injector followup

[Dave Zug]

I just took a set of cheap calipers to a stock GN injector AND to one SVO
injector and they both come up 77 MM tip to tip. They visually have the top
o-ring and bottom o-ring in the same place. The SVO injector (0 280 150 947)
electrical connector sits about 3-4 MM lower than the GN injector (0 280 150
218) connector.

I happen to have each injector set - and ONLY these injectors (sept the red
tops I have) lying here so I did this work - I hope its useful - I have no
dimensions on the stock TPI injectors - if you need the height I can get it
tomorrow.

----- Original Message -----
From: <akallotte at juno.com>
To: <gmecm at diy-efi.org>
Sent: Sunday, October 01, 2000 6:21 PM
Subject: Injector followup


> A little off topic, but we talked about this a while back.  I was
> thinking of putting GN injectors on a TPI, but I'm now hearing that
> they're too short and you have to modify the fuel rail to make them fit.
> I guess it's SVO's for me.  Thanks for all the help.  PS - DIY chips are
> starting to get some attention on the corvetteforum.com, and a lot of
> attention on thirdgen.org.  I'm keeping quiet about this list - don't
> want too many dummies like me hanging around.
> ________________________________________________________________
> YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> Juno now offers FREE Internet Access!
> Try it today - there's no risk!  For your FREE software, visit:
> http://dl.www.juno.com/get/tagj.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org