Modifying VE Tables

[Bruce Plecan]

If the BL is low (much under 128), you have too much fuel.
And need to go leaner
Bruce



----- Original Message -----
From: "Reid Bishop" <rbish at ibm.net>
To: <gmecm at diy-efi.org>
Sent: Sunday, October 01, 2000 9:26 PM
Subject: RE: Modifying VE Tables


> >>   If you can't pull fuel by other means , ADD AIR.  VE/MAP/RPM
> >>..  Depending on other variables ,
>
> I'm not sure the question was answered clearly.  If one's BLM's are LOW,
> then to adjust the VE table, should one LOWER or RAISE the appropriate
cell
> value?  I'd have to say I've seen conflicting information regarding this.
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org