howell730 bin file

[Bruce Plecan]

Some time ago, I bought one of their chips that SUPPOSEDLY was for running a
Holley 4 brl Projection with a 730.  While it was editable with a 8D editor
there were program changes.
All in all was total waste of money since the stock AUJP ran better then it.
Bruce


From: <chetwagner at uswest.net>
Subject: howell730 bin file


> A while back I was using the howell730 bin file for a project I was
> doing.  This code is an 8D mask, like the ANHT and AUJP bin's, but
> runs completely different than the others, especially at idle.  When
> idling, the integrator numbers go down about 1 every second and
> then when they reach the lower limit, they jump up to 128 and start
> to count down again.  When they reset, the fuel seems to shut off at
> the injectors but not enough to stop the engine.  I find this strange.
> If I remember right, someone noticed some extra code at the end of
> the program.  I wonder if the extra code has anything to do with the
> above.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org