Application for ASCP bin?

[rr]

Roger,

That is a decently quick car, a 1.668 60ft. What have you
done for traction?

BobR.

BobR.

Roger Heflin wrote:

> On Sat, 21 Oct 2000, Bruce Plecan wrote:
>
> > I'm using a Snap-On book, and half reading between the lines, but it looks
> > like:
> >
> > the BZDLis superceded to a 16216379 which is a BNXF that was isued to cure
> > Chuggle at 1,500-2,000 rpm, or 55-60MPH
> > The whole ASxx series show no updates
> > But, this book is a few years old now.
> >
> > Have you tired test driving it?
> > Bruce
>
> The car is *way* too modified to try running anything even close to
> stock.    I ran a 12.18 at 109 with a 1.668 60ft earlier today, after I
> get quite a bit more fuel in it, and take the header dumps off (it ran
> that through a 3" single exhaust), and should be well into the 11's on
> the motor.     Someone else sent me what is the newest chip in the
> line, so it will check it and see what it has that is different from
> the one I am running.
>
> I have run  the chip after reprogramming it, I was also worried about
> it having the correct knock module setup in it for my vehicle.
>
>                                 Thanks,
>                                 Roger
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org