Low power 5.0 TPI

[Programmer]

Would you have a section of that code handy ? It's not for
"clear flood mode" I hope <g>....
Lyndon.
-----Original Message-----
From: rr <RRauscher at nni.com>
To: gmecm at diy-efi.org <gmecm at diy-efi.org>
Date: October 27, 2000 1:45 PM
Subject: Re: Low power 5.0 TPI


>
>Actually, the tps reading looks high. There is something about the code
when
>the tps goes too high, it uses a substitute value and drops out of PE. A
few
>years back someone here ran into that with a Vette. Try setting the tps
lower.
>
>The other thing to remember is that a TPI system starts to die about there.
>Something 'bout them long runners.
>
>BobR.
>
>Programmer wrote:
>
>> Hi gurus,
>> Got a weird one here I'm trying to help a performance shop on. Subject
>> vehicle is an '88 5.0L TPI with 5 speed and 3.08 ratio--running an AKFU
code
>> '165 computer. This code was a one time vehicle Pontiac Firebird--the
whole
>> thing has been placed in an S10 truck. This thing falls flat after 4500
RPM,
>> MAF never goes above 175 g/s--pulls timing down to 12 BTDC (with no
knock)
>> and the shop swears this thing should pull like crazy with the internal
>> engine mods. This thing has the Lingenfelter <sp> intake, TPI runners,
>> etc...Dart heads, 10.5 CR, blah, blah. FP is good, TPS goes 4.7 WOT,
however
>> this truck is 12 hours away, so I can't personally test....any ideas ?
>> Lyndon
>>
>>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org