quick EFI harness question

[Garfield Willis]

On Wed, 6 Sep 2000 11:52:10 -0700, Vinnie Moscaritolo
<vinnie at vmeng.com> wrote:

>My 
>question is does anyone think there would be a problem with inserting 
>a connector (round Mil-spec AMP with gold/tin pins) in between the 
>ECM and the sensors..
>
>I didn't think there would be a resistance problem, but wanted to ask opinion.

You can avoid the fangsNclaws in this, by looking at the per-pin
current specification for your AMP connector. If it's above say around
8A, you're probly good2go since the common GM ECM connectors (Packard
Micro-Pack) we've discussed here onlist so far appear to be rated at
around 5A.

Gar


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org