knock sensor installation

[Bruce Plecan]

Should be a 1/4" pipe threaded hole (SBC)  slightly above and in front of
the starter, that's the oem spot.  (goes into water jacket)
Bruce




i am ready to install my tbi conversion on my early sbc. my question is
where/how is the best way the install the knock sensor? all my stuff came
off an 89 s15 jimmy. on this truck screwed into a hole on the bellhousing
flange. should i drill and tap a hole on my engine? i can do it, but hope
there's an easier way.
tia
ciao...douglas

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org