knock sensor installation

[steve ravet]

On smallblocks, the knock sensor is screwed into a hole just above the
oil pan on the side of the block.  There's a hole on either side,
usually with a square headed plug in it.

--steve

"s. douglas taylor" wrote:
> 
> i am ready to install my tbi conversion on my early sbc. my question is
> where/how is the best way the install the knock sensor? all my stuff came
> off an 89 s15 jimmy. on this truck screwed into a hole on the bellhousing
> flange. should i drill and tap a hole on my engine? i can do it, but hope
> there's an easier way.
> tia
> ciao...douglas
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

-- 
Steve Ravet
steve.ravet at arm.com
ARM,Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org