16197427 PCM info

[WEG1192 at aol.com]

In a message dated 7/31/2001 11:46:35 PM Eastern Daylight Time, 
shannen at grolen.com writes:

<< Be aware that the 7427 expects to see input and output shaft speed signals 
for
 4L80E applications.  I can dig out the number of teeth on these sensors if
 needed.  I believe these are less than 40 pulse/revolution sensors. >>

Yea,

I already am getting a code for low trans output speed. I plan to try and 
parrallel the single speed sensor into both inputs to solve this problem, or 
I can run two speed sensors on the same cable if separate speed sensors are 
needed.
JW
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org