Turbo V8

[Bob Wooten]

I would be careful about coating the inside of the manifold. I would not
want any of that to come off & go through the $1500 turbo(s).  I would not
have a problem with coating on the outside, though
BW
  -----Original Message-----
  From: owner-gmecm at diy-efi.org [mailto:owner-gmecm at diy-efi.org]On Behalf Of
AntiVenmVette007 at aol.com
  Sent: Tuesday, August 28, 2001 4:02 PM
  To: gmecm at diy-efi.org
  Subject: Re: Turbo V8


  In a message dated 08/28/2001 3:04:32 PM Pacific Daylight Time,
  gary.heuston at afwa.af.mil writes:



    .  Plus if I'm not mistaken having
    (relatively) long exhaust to turbo plumbing is going to introduce lots
    of lag since theres more volume to fill to get the same amount of
    exhaust pressure against the fins...




    Maybe you mis-understood me, I dont believe one could reach a much
shorter
  exhaust than I am planning. Bracketed support was what I was planning on,
but
  as far as heat goes, would a healthy Ceramic coating (in and out) be
  sufficient??
   Justin

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.diy-efi.org/pipermail/gmecm/attachments/20010828/d75d3633/attachment.html>