Need recommendations on tools.

[Scott Peitzsch]

> Which ever die grinder you decide on, I'd recommend getting a decent
> air regulator for it, if you'll be porting heads or intakes. These can
> be installed right before the quick disconnect. Trying to regulate
> shaft speed with the tool's trigger can be very touchy. However if you
> want to hear tunes while porting, then the flexshaft Dremel (electric)
> is the only way to go.

Since I'm planning on doing most of the porting work in the basement,
my inent was to use the regulator at the output of the compressor to
limit maximum tool speed.  Hopefully this will work well.

-Scott
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org