Delco 808 ECU

[Bruce Plecan]

> Nah its a dfi setup from factory with cam angle (reluctor type)... from
what
> i have read i need an 18 impulse and 3 impulse input per CRANK rev for the
> coil pack from a v6 or 36 / 6 impulses if i run it from the cam?
> also the resistance of my injectors is about 3.8 ohms.. too low for the
808
> to drive?

If an 8 cylinder then your way overloading the injector driver.
If a single injector then your fine.
The 165 can be confiured for a single Peak and Hold TBI injector, dunno
about the 808 in that repsect.
Bruce

> Regards,
>     Allan Langford


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org