T56 Questions... was : Re: Document re-uploaded

[Dave Zug.]

I've been thru that site, and I have an X-member fabbed up, it is from him,
but I got it 2nd hand. My difference is I have to put it onto an early 400
block, still a bit of research to do, but I'll get there.


Thanks steve.

----- Original Message -----
From: <OneSS2NV at aol.com>
To: <gmecm at diy-efi.org>
Sent: Sunday, January 28, 2001 9:38 PM
Subject: T56 Questions... was : Re: Document re-uploaded


> In a message to the List, Dave Zug writes:
>
> << Help me with my T-56 mating problems now -
>  taps in the block for clutch??
>  153 tooth flywheel won't accomodate an 11 inch clutch?
>  will 168 fit in T-56 housing?
>  Drill block for alternate starter?
>  (while we're off topic he hee)
>   >>
>
> Hey Dave,
>    I'm not too familiar with shift-em-yourself trannies, but this page
should
> help you out a bit.
>
> http://www.skulte.com/T56.html
>
>    It describes Andris's T56 swap into his '89 IROC.  I've been in this
> car...it works very well. :)  He also makes a X-member specifically for
the
> swap if you don't feel like fabbing one up yourself.  Hmmm...makes me
wanna
> go do a stick conversion for my Monte SS and learn how to drive with a
clutch.
>
>      HTH,
>        Steve Ragusa
>         North Jersey
>      '85 TPI Monte SS
>        '96 Impala SS
>    www.bowtiepower.com
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org