730 speed sensor

[Bruce]

Nope.
The optical sensor uses C-6 as an input, and in the AUJP (8D mask) cal.,
0018 must be changed from D8 to 98.
The 8D mask BCC are all for the magnetic set up
Bruce


From: "Daniel" <bossute at iprimus.com.au>
Subject: Re: 730 speed sensor
> Thanks Bob
> Do they both wire up to pin B9 and B10 ?
> What BCC is the magnetic for a 350 ?
> Daniel Collins
> bossute at iprimus.com.au

> From: "Bob Valentine" bob at tecmark.com
> Subject: Re: 730 speed sensor
> > The stock setup used either a 4000ppm (4 pulse/rev) magnetic or 2000ppm
(2
> > pulse/rev) optical VSS.  Calibration determines which is used.
> > -> Bob Valentine
> > -> bob at tecmark.com
> >
> > At 02:38 PM 7/8/2000 +0800, you wrote:
> > >I am trying to find out how many pulses/rev the 730 ecm requires and if
> it
> > >is a magnetic sensor or a hall effect type ?
> > >The truck has been converted when it came into Australia but no one
> bothered
> > >to fit a VSS adapter so TCC doesn't work and the idles not real good on
> > >deceleration.
> > >I can get a 8 pulse magnetic inline VSS but wasn't sure what the 730
> > >requires
> > >
> > >Daniel


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org