More interesting (I hope?) CrossFire Stuff....

[Marc Piccioni]

Ken,

Could you post the link to Peter's page please.

Thanks


gmecm at diy-efi.org wrote:
>Dave, I never actually posted them here. I'm still in the process of
>testing
>everything to make sure it all works. I've hooked all the emissions stuff
>(AIR, can purge, etc.) up but I'm not getting any lights on my
>tattle-tale
>box for them. I simply took the '7747 wiring diagram and crossed it with
>the
>CrossFire wiring diagram. I made an Excel spreadsheet that references the
>two, so I just sit down for half a day and cross out the numbers as I go
>down the list wiring it. For that matter, I have a feeling my 4th gear
>switch in my 700R4 isn't working, either. (I'm not getting a light for
>it.)
>I might just have it wired wrong, for all I know at this point.
>
>The "tattle tale" box is simply 6 LED's each with their own current
>dropping
>470 ohm resistor, and each one is wired onto the pigtail directly. I
>mistakenly wired it to "battery" when I really should have wired it to
>"switched ignition" .. I'll pull it out today and re-wire it accordingly.
>(Yes, the LED's have been on all night!)
>
>Peter's ALDL interface is from his 160serial.htm page, using RX instead
>of
>CTS (version 1.5 of his ALDL reader.) I incorporated it into the pigtail
>itself so I wouldn't have to run +12v to the laptop's DB9 connector (and
>have the electronics flopping around inside the DB9.) Now I just have a
>shielded 1-conductor cable with a 1/8" mono jack going to the laptop. It's
>a
>much cleaner installation than what I had before. (Had the +12v running
>over
>to the fuse box under my floor mat!)
>
>When I'm 100% positive it's all working properly, I'll post the wiring
>diagrams. So far, I have yet to get a check engine light (other than
>startup, when it's supposed to come on.)
>
>Ken
>
>-----Original Message-----
>From: owner-gmecm at diy-efi.org [mailto:owner-gmecm at diy-efi.org]On Behalf
>Of David & Cheryl Haggard
>Sent: Monday, July 16, 2001 10:07 AM
>To: gmecm at diy-efi.org
>Subject: RE: More interesting (I hope?) CrossFire Stuff....
>
>
>Ken,
>   Maybe I missed it somewhere, but... You have wiring diagrams for all
>this?
>
>Dave Haggard
>
>
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
--
  Marc Piccioni -- piccioni at cadvision.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org