160 Baud Interface

[Louis Baiani]

Okay, I was kinda talking about the version that you can enter calculation
formulas?  Remember I asked you about that Peter?

Louis


Peter Gargano wrote:

> Louis Baiani wrote:
> >
> > When is Peter going to release that new version we were once talking about?
>
> About five minutes ago!  Well, actually, it's still version 1.5A, but
> I've now made it available to everyone from:
>
>   http://www.techedge.com.au/vehicle/aldl160/aldl_sw.htm
>
> This is the version with logging that runs with the 8192 baud interface on the
> Rx pin (rather than the CTS pin) although it'll still run the "old" interface
> too. This "new" interface is partly described here:
>
>   http://www.techedge.com.au/vehicle/aldl8192/8192hw.htm
>
> You still have to supply a valid email address tho' as I still email attach it
> to whatever you tell me is your email. So - I get a lot of bounce notifications
> for someone called  "asdfg at qwerty.com" (but I know your IP address .... ;-).
> The idea is that I can notify you of updates this way, and I have an idea of
> who is using this software.
>
> And I really do have an 8192 baud version I'm still trying find time to add the
> finishing touches to  :-(
>
> I'd appreciate any feedback on grammar and spelling mistakes on my unproofed
> HTML pages mentioned above, or, if anyone has trouble accessing the pages or the
> software:
>
>    mailto:peter at techedge.com.au?subject=160_feedback
>
> Peter.
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org