Knock sensor on Pontiac 6000

[Louis Baiani]

Oh I think MPI has EST...god CLCC systems have EST :O)

JTesta1966 at aol.com wrote:

> In a message dated 7/23/01 11:32:55 AM Eastern Daylight Time,
> smarteney at xlvision.com writes:
>
> << Does a circa-1988 Pontiac 6000 with 2.8L MPI V6 have a knock sensor?  (This
>  particular car is marked as being converted to speed density.)  If it does,
>  where is it?  It must be on the firewall side of the block, the only side I
>  couldn't get to this weekend (long story).  Also, is the knock sensor the
>  same (or similar) to that of a V8 TPI 91-92 such that I can steal the
>  connector???  It's the only missing piece for my 165-to-730 conversion.
>   >>
>
> If memory serves me the knock sensor is above the starter. Maybe yours is pre
> EST?
>
> ================================================
> Jim (FA) Testa                                 Type86 on buick.fiendish.net
> ASE Cert Master Tech                                 jtesta1966 at aol.com
> L1 Adv Engine Performance                     http://www.turbojim.com
> <A HREF="http://www.ajlc.waterloo.on.ca/gnsearch.html">Search the GNTTYPE
> archives
> </A>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org