BatV

[Bruce]

Nope, he had it right, and moving the 8 ga wouldn't hurt.
Bruce



From: "rr" <RRauscher at nni.com>
Subject: Re: BatV
> My brother did this on his car. Two cables, one to the engine & the other
to
> the starter. His car starts easily and cranks fast. I was also thinking
that the
> 8 awg should run  from the J block to the battery. That way the cable drop
> during crank won't affect the ECM.
> All this time I kinda' thought he went over-board. . . Maybe not.
> BobR.
> P.S. And a thanks to all of the other replies. One less thing to worry
about
> now.

> Bruce wrote:
> > >From where the neg ties to the body (assuming it's a short run), run a
> > second 1/0 to the engine.  Also, run one and perferably two grounds to
the
> > body.   While it might not change anything short term, long term you'll
> > thank me.  Main power and grounds even to those that know how important
they
> > are, are often not done well enough.
> >    I always have a single heavy battery ground going to the actual
engine
> > block, not the head, not the timing cover, the block.
> >    In places where it gets cold, the first couple milliseconds the
starte
> > load is hundreds of amps, and for the ecm to get a clear and accurate
> > voltage sense, can be difficult.
> > Bruce
> >
> > From: "rr" <RRauscher at nni.com>
> > Subject: Re: BatV
> > > Have 1/0 from battery to starter, then 8awg from starter to J block.
> > > Body is ground return. ECM picks up power from J block. Also
> > > have heavy duty switch on gnd line, 1/4 volt lost right there.
> > > BobR.
> >
> > > Bruce wrote:
> > > > Me, Doc, and Sleepy all draw the line at 9.0V
> > > > What ga. wiring ya using?.
> > > > Bruce
> >
> > > > From: "rr" <rrauscher at nni.com>
> > > > Subject: BatV
> > > > > Have a good question: what is the minimum acceptable
> > > > > battery voltage during crank? I put a DVM across the
> > > > > battery terminals, pulled the fuel pump fuse and cranked
> > > > > for ~10 seconds. Battery drops to ~10.7 volts and holds
> > > > > during the cranking.
> > > > > For a charged battery & good starter is this a bit low?
> > > > > EFI content: The ECM will still fire the injectors and
> > > > > the engine starts with this low of a battery voltage.
> > > > > The ECM reports the BatV term to be at 9.0 volts during
> > > > > crank. Lots of loss with the battery in the trunk!
> > > > > BobR.
> >
>
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org