GM injector GM 5235279*RPD

[rr]

Most likely because the hacs were not yet available. Folks  actually
set up flow benches to test the flow rates. Being that GM specs the TBI
regulator pressure at 9 to 13 psi, testing at 9 psi would yield different
results then testing at 13 psi. Other problems abound also. I found
evaporation to be quite a problem when flow testing.

BobR.


WEG1192 at aol.com wrote:

> In a message dated 7/30/2001 1:55:19 PM Eastern Daylight Time, sravet at arm.com
> writes:
>
> << According to the TBI injector page:
>
>  Green/White      5.0L        40 lb/hr    GM 5235279 *RPD
>
>  http://diy-efi.org/gmecm/component_info/tbi_injectors.html
>
>  --steve >>
>
> I have come across a discrepancy with that page. I took the BPC numbers from
> stock bins knowing the displacement and injector colors and back calculated
> the flow rates for the 4.3L, 5.0L, and 5.7L injectors using Tunercats
> formula. My calculations show 45, 50, and 61 #/hr respectively. Anyone have
> any comments why they are different from the table at GMECM? JW
> ----------------------------------------------------------------------------

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org