Externally mountable IAC

[Brian Roth]

Sounds promising except I do not know if I have a space large enough to put
a hole that big in the TB. I would like to try to do it with vacuum hoses
connecting the IAC to external ports. I hope I am explaining this well.

Brian 

> ----------
> From: 	Tedscj at aol.com
> Reply To: 	gmecm at diy-efi.org
> Sent: 	Tuesday, March 20, 2001 11:22 PM
> To: 	gmecm at diy-efi.org
> Subject: 	Re: Externally mountable IAC
> 
> In a message dated 3/20/01 11:58:51 AM Eastern Standard Time, 
> broth at sanjuan.edu writes:
> 
> << Do you have any idea what the application would be for one of those
> IAC's 
> on
>  the removable housing? I assume you are talking about a GM application.
> >>
> 
> 
> I made a custom IAC housing from the removable housing from a 2.8/3.1 
> (Beretta, Corsica, Grand Prix, etc.)  I think that is your best bet.
> I just trimmed off the extra aluminum that I did not need.  I then bolted
> it 
> right up to the open space that was once occupied by a cold start injector
> 
> (Bosch L-Jetronic).  It lined right up (bolt holes and everything) as if
> it 
> were meant to be there all along.
> --------------------------------------------------------------------------
> --
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> 
> 
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org