dyno stuff

[Eric Bryant]

> Clear--perfectly. There's no data to "input" into the MAHA software.
> Therefore it is
> measuring raw data at the rear wheels. Just having a little 
> trouble how the
> HP numbers
> are calculated...
>

Well, torque multiplication is RPM division.  The equation for HP is:

HP = RPM*Torque(ft-lbs)/5252

So, if the torque is multiplied and the rotational speed is divided by an
equal factor, HP comes out to be the same.  That's what the dyno is
calculating.

Eric Bryant
mailto:bryante at ghsp.com
http://www.novagate.com/~bryante  

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org