Memcals & Netres

[steve ravet]

The K (or M or R) is placed where the decimal would be.  9K6 means
9.6Kohms.  4M1 would be 4.1Mohms.  1R6 is 1.6 ohms, and 0R0 is a zero
ohm resistor, or a wire.  Caps are similar.  NOFIT means there are pads
for the component on the board but one was not fitted for whatever
reason.

--steve

Stephen.Kaminska at HSC.com wrote:
> 
> Nice schematics, no reason to redraw them.  But have questions about
> several of the component values.
> For example, resistor Z5H is 9K6 - is this 9 k ohm, 9 Meg ohm, or?  Or
> resistor Z4C is 0R0 -  a zero ohm resistor?  Assume NOFIT means you could
> not get a value for that part?  Same problem with some capacitors, such as
> C9 labeled 2u7 -  2 uF, 20uF, or?
> 
> Hope you can clarify.
> 
> Rick
> mailto:rick at SoCalSS.org
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

-- 
Steve Ravet
steve.ravet at arm.com
ARM,Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org