limp 7730

[Fisystems at aol.com]

Looking at the code @ 16 
I have 0, I think the AUJP was 16
b7 ?
b6 Use A/D Batt for inj lk up,  (else use pump VDC) ** What about this??**
b5 Open loop purge
b4 Enable VATS
b3 Let low TPS Dis CCP
b2 4th gear switch
b1 16hz ccp in use
b0 rpm for TCC vs MPH



In a message dated 5/10/2001 12:35:46 AM Pacific Daylight Time, 
ludis at cruzers.com writes:

<< Fisystems at aol.com wrote:
 > 
 > The
 > problem is the thing will go into limp mode every time I shut it off and 
try
 > to restart it. When it restarts it's in the limp mode. [...] I moved the
 > battery power to switched power so that I can shut it off and than restart 
it
 > without having to disconnect and reconnect it. With it wired that way if 
the
 > engine stalls and the power switch is still on, I can watch the scanner 
lose
 > communication after about three seconds. If I just hit the start button
 > without turning the power off and back on it's in the limp mode. Any 
ideas? >>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org