Calpack verification

Kieran Alexander Cox kcox at polymail.cpunix.calpoly.edu
Sun May 13 08:17:14 GMT 2001


Any recommendations on an easy way to get the ECM out of a C4 corvette?
Specifically an '86?





Kieran Cox


===============================================================================
Kieran A. Cox			*     *		  
1-805-801-4188					 
1351 Royal Way #2        
SLO, CA, 93405                     

===============================================================================


On Sat, 12 May 2001, Matt Sandine wrote:

> I had pulled a few 870 ECM's from a junkyard. The car is an '85
> Corvette...maybe I am using the wrong calpack. It shows 16042438.
> 
> Doesn't the calpack just work in limp home mode? Say I unplug the O2 sensor
> for a minute so that I get no voltage to the computer. I would set a code.
> Then I could check the timing there. If limp home mode timing was correct,
> then I can keep going from there. Regards, -Matt-
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> 
> 

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org




More information about the Gmecm mailing list