code 44 - why?

[Programmer]

Are the MAF tables exactly the same between bins ?

Lyndon.
----- Original Message -----
From: den Broeder, Ernst <edenbroe at cisco.com>
To: <gmecm at diy-efi.org>
Sent: Wednesday, May 16, 2001 11:52 AM
Subject: code 44 - why?


> I had an interesting experience with my TPI setup in the past 2 days since
> I got it running.  It's a 1989 MAF '165 system on a 5.0L with TPI.
>
> I have been using AUJM (350, auto, 3.27, FED) and it keeps setting code 44
> on me.  I switched over to a APYS (305,M5,3.45) and the problem goes
away...
>
> Could someone please explain why I see this behavior?  I checked through
> the archives and found a few tidbits that lead me to believe it's just a
> case of the definition of what is lean and what is rich...?   What I don't
> understand is why it would be different for different engine
> displacements.  Could it be because the O2 sensor is sensitive to the
extra
> back pressure a 350 (as opposed to a 305) would apply against a set of
> factory exhaust manifolds?
>
> Ernst
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org