Finding injector rate ($a1 stuff)

[Jeremy Gonyou]

Whew, that's not what I have.  What FAQ are you
referring to?  And where did you come up with (I
assume you mean) x86C6?  
According to my hacking, bpw is not a single byte
value.  It starts with a "Base Pulse Constant" that is
a 2D lookup with EGR flow.  This table is at x8761. 
If you go through the math, this gives you a injector
constant of 14.9 lb/hr ... IIRC.  

Have you changed your injectors?  If not the point is
probably mute anyway.  
Also, how did you pull this ecu together?  Do you have
a hack you could share with the class?

My $A1 stuff is here if ya wanna check it out (It's
not ready for prime-time yet). 
http://www.geocities.com/jeremygonyou/a1.zip  

Jeremy

PS  I'm fairly certain $A1 never control and auto
trans.  Perhaps you're thinking of TCC control?



> I know the FAQ tells you how to find the injector
> constant, but that doesn't
> work for my code.  On the A1 code, its located at
> 0x06C6.  On mine, it equal
> 512.  However, the stock injectors are 16#, which
> should be 636 converted to
> hex.   That would make them almost 20# injectors.




__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org