sealing an ECM ?

[Programmer]

I've shielded it with the original "plastic" case that housed the "flash"
and built a nice brushed aluminum cover for the top. It's not water
proof...but it definitely keeps the under hood temps away from the ECM. Wish
I had a good digital camera...

Lyndon.
----- Original Message -----
From: "Rob MacMorran" <rmacmorran at yahoo.com>
To: <gmecm at diy-efi.org>
Sent: Friday, August 31, 2001 1:20 PM
Subject: Re: sealing an ECM ?


> What about heat dissipation?
> --- Programmer <nwester at eidnet.org> wrote:
> > Guys--underhood ECM location is not a great idea,
> > unless I can seal this
> > thing from the environment...anyone
> > BTDT ? I'm thinking about dipping the circuit board
> > at
> > this point...Plasticoat makes a non-conductive
> > dipping
> > solution that'll harden in about 2-3 hours...going
> > to give that a whirl.
> >
> > Lyndon.
> >
> >
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm"
> > (without the quotes)
> > in the body of a message (not the subject) to
> > majordomo at lists.diy-efi.org
> >
>
>
> __________________________________________________
> Do You Yahoo!?
> Get email alerts & NEW webcam video instant messaging with Yahoo!
Messenger
> http://im.yahoo.com
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org