sealing an ECM ?

[Programmer]

Just going to dunk the C/B...not the case. Yes--
have already greased the connections--GM uses
it, too.

Lyndon.
----- Original Message -----
From: "Len Sabatine" <sabatine at epix.net>
To: <gmecm at diy-efi.org>
Sent: Friday, August 31, 2001 4:05 PM
Subject: Re: sealing an ECM ?


>      Locktite offers a sealant for the purpose of sealing the PCB, I'm not
>      so sure it's meant to dunk a case tho. Fomoco BTW uses gobs of
>      Lithium  / Dielectric grease in their connectors, throughout the
vehicle
>      on the wire harness connectors.
>      I can't say If the Plasticoat Material you've got at hand is go or no
go.
>      Len
>
> >Guys--underhood ECM location is not a great idea, unless I can seal this
> >thing from the environment...anyone
> >BTDT ? I'm thinking about dipping the circuit board at
> >this point...Plasticoat makes a non-conductive dipping
> >solution that'll harden in about 2-3 hours...going to give that a whirl.
> >
> >Lyndon.
> >
>
>---------------------------------------------------------------------------
-
> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> >in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org