[Gmecm] Crane Gold self-aligning rockers.

[Rick McLeod]

I'm running a '87 tpi w/ crane compu-cam lifting stock
roller-hydraulic lifters to crane gold race roller
rockers, aggressively tuned chip and only see knock
counts if I run <= 91 and it's a really warm day w/ a
heavy foot.

This is a somewhat different valve train than the
LT's, though, so there may be difference in the noise
comming off the valve train.

I haven't see any one yet reply to my suggestion to
listen to the engine w/ a stethescope, it's an old
timer's method I admit, but still holds water :-).

SNIP'd> >>>>
> >>>> There has been a whole lot of talk lately with
> the ECM's knock system 
> >>>> and
> >>>> Crane's rockers. I just wondered, if there's
> anyone else on this list,
> >>>> that successfully runs these rockers without
> increasing the knock 
> >>>> count,
> >>>> besides me?
> >>>>
> >>>> ---
> >>>>
> >>>>
> >>>> _______________________________________________
> >>>> Gmecm mailing list
> >>>> Gmecm at diy-efi.org
> >>>> http://lists.diy-efi.org/mailman/listinfo/gmecm
> >>>
> >>> _______________________________________________
> >>> Gmecm mailing list
> >>> Gmecm at diy-efi.org
> >>> http://lists.diy-efi.org/mailman/listinfo/gmecm
> >>>
> >>
> >> _______________________________________________
> >> Gmecm mailing list
> >> Gmecm at diy-efi.org
> >> http://lists.diy-efi.org/mailman/listinfo/gmecm
> >
> > _______________________________________________
> > Gmecm mailing list
> > Gmecm at diy-efi.org
> > http://lists.diy-efi.org/mailman/listinfo/gmecm
> > 
> 
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/gmecm
>