[Gmecm] TBI Swap - Iron Duke Tech IV

[Aphelion79]

Okay, can anyone point me out to a diagram that shows what each wire in 
the two connectors (looks like two 32 pin connectors) for the 1227748 
ECM goes to?

>>    
>>
>>>-----Original Message-----
>>>From: gmecm-bounces at diy-efi.org
>>>[mailto:gmecm-bounces at diy-efi.org] On Behalf Of Aphelion79
>>>Sent: Wednesday, February 15, 2006 2:40 PM
>>>To: gmecm at diy-efi.org
>>>Subject: Re: [Gmecm] TBI Swap - Iron Duke Tech IV
>>>
>>>Anyway, to the others...
>>>"Just for your information, this is not a distributor, it is
>>>the DIS system. The "shaft" is actually the crank sensor. It
>>>should work just fine with a 7748 with no timing issues. "
>>>
>>>What is a 7748?
>>>
>>>
>>>      
>>>
>>7748=1227748, a P4 type ECM used in 4 cyl fieros and probably other
>>cars.  Take a look at www.cruzers.com/~ludis at the P4 crossreference to
>>find out what applications it was used in.
>>
>>I happen to have one of these (reman) that I could be persuaded to part
>>with.
>>
>>--steve
>>
>>
>>-- IMPORTANT NOTICE: The contents of this email and any attachments are
>>    
>>
>confidential and may also be privileged. If you are not the intended
>recipient, please notify the sender immediately and do not disclose the
>contents to any other person, use it for any purpose, or store or copy the
>information in any medium.  Thank you.
>  
>
>>_______________________________________________
>>Gmecm mailing list
>>Gmecm at diy-efi.org
>>http://lists.diy-efi.org/mailman/listinfo/gmecm
>>
>>
>>
>>    
>>
>_______________________________________________
>Gmecm mailing list
>Gmecm at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/gmecm
>_______________________________________________
>Gmecm mailing list
>Gmecm at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/gmecm
>
>  
>