[Gmecm] MECAL reprogramming

[David Allen]

Bill, that's what I thought at first, but the Memcal's connector holes are
one "row" of PC board holes apart.  The PP2 is just BARELY too narrow!
If I had the time I would make a custom board with a Memcal socket out of an
old junk ECM, and a ribbon-cable header to go to the PP2. But this ugly
little board works for now...
Later,
David


----- Original Message ----- 
From: "Bill Shaw" <b.shaw at comcast.net>
To: <gmecm at diy-efi.org>
Sent: Sunday, February 26, 2006 5:52 AM
Subject: Re: [Gmecm] MECAL reprogramming


> If your programmer is like most of the ones I've seen (the pic looks like
it
> is)  you don't need to bend the pins,  they'll fit into the programmer
> straight.
>
> Bill
>
> > From: "David Allen" <davida1 at hiwaay.net>
> > Reply-To: gmecm at diy-efi.org
> > Date: Sat, 25 Feb 2006 21:58:13 -0800
> > To: <gmecm at diy-efi.org>
> > Subject: Re: [Gmecm] MECAL reprogramming
> >
> > It is cheap, and it is dirty but it does work! The spread-out pins lock
> > into the ZIF socket on the PP2, and the straight pins form a header for
the
> > Memcal to plug into.
> > See temp folder link below.
> > Later,
> > David
> >
> > http://home.hiwaay.net/~davida1/temp/
> >
> > _______________________________________________
> > Gmecm mailing list
> > Gmecm at diy-efi.org
> > http://lists.diy-efi.org/mailman/listinfo/gmecm
>
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/gmecm
>