[Gmecm] Acquiring ECM schematic

[Ryan Hess]

And what about schematics?  <grin>

I think you can get away with anything if you slap the "for offroad use only" sticker on it.



William Lucke <william.lucke at highspeedlink.net> wrote: The secretive environment may stem in part from EPA regulations. I 
mentioned DIY ECM programming to Allen Cline once and he commented that 
GM had no licensed anyone to do anything with the code and said that 
providing me with an uncertified program for the Cadillac Northstar 
could cost him his job, because it would amount to a violation of EPA 
regulations regarding MFG's putting out non-emissions compliant info/parts.

Heaven forbid that 0.0000000002% of cars on the road have tweaked 
ECM's... Typical government bullshit.



Will


> From: Ryan Hess 
> Subject: RE: [Gmecm] Acquiring ECM schematic
> 
> Wow, I did not know that.  I can't imagine going through a 4 layer board, and worse, trying to figure out what IC does what.
> 
> Who would you suggest I request information from?  Delphi?  Who built their early 90's OBDI ECM's?  
> 
> As sort of an aside, GM stopped making/supporting the 1228331 ECM found on ZR1 vettes and the turbo lotus.  There was another part # that superceeded it, but I believe it too had been discontinued.  What are those people to do?  They don't exist in junkyards (I've looked), and there's *one* on ebay for nearly $600.  If GM doesn't release the schematic for it, wouldn't they be out of luck?  
> 
> This secretive environment is just terrible.  These things are approaching 15-20 years old now.  
> 
> 
> 
> davesnothereman at netscape.net wrote: Ryan Hess  wrote:
> 
>> Question: how have ECM schematics been acquired in the past? ???the 
>> 7730/49 on ludis' site, etc?
> Old fashioned reverse engineering.
> 
>> I'm in contact with an ECM remanufacturer, who 
>> presumably has a great deal of knowledge locked away somewhere. ???The 
>> question is, how do I coerce it out of them? ???
> 
> Maybe you should request information as an ecm remanufacturer?  There are a few rebuilders, they must have obtained information in some way.
> I'm specifically looking 
>> for a schematic of a '2240.
>>
>>
>> I have to assume this is like the TV repair business, where the mfr 
>> charges a fee for access to their schematics..
> 
> They may not release schematics at all.  GM is a provider of rebuilt ecm's.  They have no need to support the business of repairing and rebuilding computers.
> 
> I know that it's easier to pull a hen's teeth than obtain Delco service information for audio products, even those which are 15 years old.  And once you get service info, finding parts is even tougher.
> 
> Zaphod
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm


 __________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com