Ang: Re: [Gmecm] Heated O2 Current Draw

[Per Lonnborg]

I am also into converting to a heated O2 sensor, is the heater circuit activated as soon as ignition is turned on, and then stays on until 
engine/ignition is cut off?

/Per

>----Ursprungligt meddelande----
>Fr?n: dmumert at telusplanet.net
>Datum: 2006-mar-07 17:31
>Till: <gmecm at diy-efi.org>
>?rende: Re: [Gmecm] Heated O2 Current Draw
>
>Hi Mike
>
>The Bosch LSM 11 requires 18 watts at 12-14 volts.  That is about 1.5 amps.
>
>Dave
>
>----- Original Message ----- 
>From: "Mike Poore" <mp at flowersbyvalerie.com>
>To: <gmecm at diy-efi.org>
>Sent: Tuesday, March 07, 2006 9:23 AM
>Subject: [Gmecm] Heated O2 Current Draw
>
>
>> Does anyone know the current draw for the heater circuit on a heated O2 
>> sensor?
>> 
>> I need to convert to a heated sensor.
>> 
>> Mike
>> _______________________________________________
>> Gmecm mailing list
>> Gmecm at diy-efi.org
>> http://lists.diy-efi.org/mailman/listinfo/gmecm
>_______________________________________________
>Gmecm mailing list
>Gmecm at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/gmecm
>