[Gmecm] 4-Cyl 2.5L 151 CID Iron Duke TBI Converstion, Wiring Question:

[Aphelion79]

Uh, perhaps I should quote what I just wrote:
"

So,
What can I use for my ignition coil power?  Perhaps use the old ignition 
coil positive wire to trigger a relay... which, when the ignition turns 
on, gives current to the ECM I, and also the PINK wire (far right hand 
side on the "IGNITION COIL"?
"


I.e. instead of a snide remark... maybe a "Yes, what you suggested would 
be safe to do." or a "NO WAY, don't do that it will turn your vehicle 
into a toaster!!, wire it to this (or wire it this way) instead."

However, thank you for the reply... at least I know you exist... if that 
helps me out any?

Anyone else have a constructive comment to share?

Thanks again,
Matt W.

Denny wrote:

>Uh Ignition switch?
>
>-----Original Message-----
>From: gmecm-bounces at diy-efi.org [mailto:gmecm-bounces at diy-efi.org]On
>Behalf Of Aphelion79
>Sent: Monday, March 20, 2006 7:04 PM
>To: gmecm at diy-efi.org
>Subject: [Gmecm] 4-Cyl 2.5L 151 CID Iron Duke TBI Converstion,Wiring
>Question:
>
>
>Hey all again...
>    I've got everything hooked up... everything is seeming to get 
>power... except I've got no spark.  I looked around and realized, what 
>in the world is powering my ignition coil?  Nothing, oh great! LOL 
>OOPS... so my question to you all is, what can I wire that baby into?
>
>Check diagram:
>http://myweb.unomaha.edu/~mjwhitney/s10wiringdiagram.pdf
>
>---
>
>Starting at top left:
>HOT IN START OR RUN
>ECM I
>10A... I have this wired into my OLD ignition switch positive wire... 
>that USED to go to the old ignition coil... on a 10A fuse...
>
>A bit lower, just next to the FUEL INJECTOR
>HOT IN START
>CRANK
>20A... I have this wired onto the little post on my starter solenoid... 
>on a 20A fuse...
>
>Back to the top, two more lines over:
>HOT AT ALL TIMES
>ECM B
>10A... I have this wired into my Alternator Post... on a 10A fuse...
>
>---
>So,
>What can I use for my ignition coil power?  Perhaps use the old ignition 
>coil positive wire to trigger a relay... which, when the ignition turns 
>on, gives current to the ECM I, and also the PINK wire (far right hand 
>side on the "IGNITION COIL"?
>
>I'm kinda electrically challenged... so please help me out if you can!
>
>Thanks!
>-Matt W.
>_______________________________________________
>Gmecm mailing list
>Gmecm at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/gmecm
>_______________________________________________
>Gmecm mailing list
>Gmecm at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/gmecm
>
>  
>