[Gmecm] 4-Cyl 2.5L 151 CID Iron Duke TBI Converstion, Wiring Question:

[Denny]

Uh Ignition switch?

-----Original Message-----
From: gmecm-bounces at diy-efi.org [mailto:gmecm-bounces at diy-efi.org]On
Behalf Of Aphelion79
Sent: Monday, March 20, 2006 7:04 PM
To: gmecm at diy-efi.org
Subject: [Gmecm] 4-Cyl 2.5L 151 CID Iron Duke TBI Converstion,Wiring
Question:


Hey all again...
    I've got everything hooked up... everything is seeming to get 
power... except I've got no spark.  I looked around and realized, what 
in the world is powering my ignition coil?  Nothing, oh great! LOL 
OOPS... so my question to you all is, what can I wire that baby into?

Check diagram:
http://myweb.unomaha.edu/~mjwhitney/s10wiringdiagram.pdf

---

Starting at top left:
HOT IN START OR RUN
ECM I
10A... I have this wired into my OLD ignition switch positive wire... 
that USED to go to the old ignition coil... on a 10A fuse...

A bit lower, just next to the FUEL INJECTOR
HOT IN START
CRANK
20A... I have this wired onto the little post on my starter solenoid... 
on a 20A fuse...

Back to the top, two more lines over:
HOT AT ALL TIMES
ECM B
10A... I have this wired into my Alternator Post... on a 10A fuse...

---
So,
What can I use for my ignition coil power?  Perhaps use the old ignition 
coil positive wire to trigger a relay... which, when the ignition turns 
on, gives current to the ECM I, and also the PINK wire (far right hand 
side on the "IGNITION COIL"?

I'm kinda electrically challenged... so please help me out if you can!

Thanks!
-Matt W.
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm