[Gmecm] Does $a1 have a "stall saver" algorithm?

[Ryan Hess]

Wait, what are these:

Low RPM thresh to disable EST [KESTRPMD] - 300 RPM
High MAP thresh to disable EST [KMAPSTAL] - 70 kpa

Both must be true at the same time, then the EST is cut?  Does that mean it defaults to the DIS module's advance of 10 degrees?  What's the point of that?  If idle advance is 16-20, dropping it to 10 would surely kill the motor?

Second, there is:

RPM thresh to stop Spark Advance Filtering [KSFILRPM] - 800
I don't know what that does, but my RPM is about 200 lower than stock, should that be lowered too?  (my idle is about 700, stock 3.1 idle I believe is 900)

Thanks in advance,

Ryan

Ryan Hess <rgmecm at yahoo.com> wrote: I can't seem to find any minimum RPM constants listed anywhere....  Any ideas?

Ryan

     
---------------------------------
Get your own web address for just $1.99/1st yr. We'll help. Yahoo! Small Business.
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
Main WWW page: http://www.diy-efi.org/gmecm


 		
---------------------------------
Get your email and more, right on the  new Yahoo.com