[Gmecm] Does $a1 have a "stall saver" algorithm?

[davesnothereman at netscape.net]

 These are conditions to enable EST after startup.  Your engine RPM should not be dropping to 300.
 
Zaphod
 
 
-----Original Message-----
From: rgmecm at yahoo.com
To: gmecm at diy-efi.org
Sent: Thu, 7 Sep 2006 9:37 PM
Subject: Re: [Gmecm] Does $a1 have a "stall saver" algorithm?


Wait, what are these:

Low RPM thresh to disable EST [KESTRPMD] - 300 RPM
High MAP thresh to disable EST [KMAPSTAL] - 70 kpa

Both must be true at the same time, then the EST is cut?  Does that mean it 
defaults to the DIS module's advance of 10 degrees?  What's the point of that?  
If idle advance is 16-20, dropping it to 10 would surely kill the motor?

Second, there is:

RPM thresh to stop Spark Advance Filtering [KSFILRPM] - 800
I don't know what that does, but my RPM is about 200 lower than stock, should 
that be lowered too?  (my idle is about 700, stock 3.1 idle I believe is 900)

Thanks in advance,

Ryan

Ryan Hess <rgmecm at yahoo.com> wrote: I can't seem to find any minimum RPM 
constants listed anywhere....  Any ideas?

Ryan

     
---------------------------------
Get your own web address for just $1.99/1st yr. We'll help. Yahoo! Small 
Business.
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
Main WWW page: http://www.diy-efi.org/gmecm


        
---------------------------------
Get your email and more, right on the  new Yahoo.com 
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
Main WWW page: http://www.diy-efi.org/gmecm
________________________________________________________________________
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.