[Gmecm] in need of Engine diagram help

[Mike V]

Thanks for the reply Jason.
It _did_ go to the valve cover.
It was tough to reach.
I got it after removing some other parts
and using imaginative words.
mv

----- Original Message ----- 
From: "Jason M." <galaxiecustom500 at sbcglobal.net>
To: <gmecm at diy-efi.org>
Sent: Thursday, February 15, 2007 10:45 PM
Subject: Re: [Gmecm] in need of Engine diagram help


> Not familiar with that application, if it's something like a 3/8'' hose It 
> probably runs down to the rocker arm cover and some sort of a gromet, or 
> the pcv valve.
>
>
> ----- Original Message ----- 
> From: "Mike V" <efi at dyakron.com>
> To: <gmecm at diy-efi.org>
> Sent: Thursday, February 15, 2007 9:13 PM
> Subject: [Gmecm] in need of Engine diagram help
>
>
>> Hi all,
>> The parts store closed 5 minutes ago, and I just pulled a mystery hose 
>> off of the 3400 engine in my wife's 2001 Chevy Venture Van.
>> One end connect near the MAF sensor in the rubber intake boot.
>> The engine is up under a cowl, and of couse this
>> plastic hose connects on the rearward side somewhere.  I've been trying 
>> the brail method
>> with no luck.  Too tight to even get a small
>> mirror back in there.  I really need a drawing
>> or a diagram of the top side of the 3400 60* V6.  One end of the hose 
>> connects to the flexible rubber boot that connects to the MAF and air 
>> filter box.  I think the other end
>> connects to crankcase air somewhere, but I can't see back there to 
>> connect it.
>> Any help would be greatly appreciated.
>> TIA MV
>> _______________________________________________
>> Gmecm mailing list
>> Gmecm at diy-efi.org
>> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
>> Main WWW page: http://www.diy-efi.org/gmecm
>>
>
>
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm