[Gmecm] in need of Engine diagram help

[Jason M.]

Not familiar with that application, if it's something like a 3/8'' hose It 
probably runs down to the rocker arm cover and some sort of a gromet, or the 
pcv valve.


----- Original Message ----- 
From: "Mike V" <efi at dyakron.com>
To: <gmecm at diy-efi.org>
Sent: Thursday, February 15, 2007 9:13 PM
Subject: [Gmecm] in need of Engine diagram help


> Hi all,
> The parts store closed 5 minutes ago, and I just pulled a mystery hose off 
> of the 3400 engine in my wife's 2001 Chevy Venture Van.
> One end connect near the MAF sensor in the rubber intake boot.
> The engine is up under a cowl, and of couse this
> plastic hose connects on the rearward side somewhere.  I've been trying 
> the brail method
> with no luck.  Too tight to even get a small
> mirror back in there.  I really need a drawing
> or a diagram of the top side of the 3400 60* V6.  One end of the hose 
> connects to the flexible rubber boot that connects to the MAF and air 
> filter box.  I think the other end
> connects to crankcase air somewhere, but I can't see back there to connect 
> it.
> Any help would be greatly appreciated.
> TIA MV
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm
>