[Gmecm] PCM-6 Turbo

[Robert Saar]

assuming nobody else has, i wouldn't mind sharing the patch i made for nAst1 to allow up to 3BAR support. you may have to do some digging to find where to apply the jump/return locations, but otherwise it's been bench-tested.
?
the way i have it setup now, it accounts for fuel via a 2d table with 10kPa increments to 300kPa as a BPW mulitplier. for spark, i just have a basic "retard vs kPa" table that runs from 100 to 300kPa.

--- On Wed, 11/7/12, Bill Hamilton <scoutii76 at hotmail.com> wrote:


From: Bill Hamilton <scoutii76 at hotmail.com>
Subject: [Gmecm] PCM-6 Turbo
To: "gm ecm" <gmecm at diy-efi.org>
Date: Wednesday, November 7, 2012, 8:15 PM






Anyone played with the code for the PCM-6/7427/8625? etc... to allow 2 or 3 bar map for turbo application?
?
I'm running the $0E with MPFI and the 4l80E but thinking of adding a turbo.
I've seen the WB code but haven't seen anyone mention turbo/supercharger addition.
?
Thanks,
Bill USN-1

-----Inline Attachment Follows-----


_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/gmecm/attachments/20121107/b66b8496/attachment.html