[Gmecm] PCM-6 Turbo
Bill Hamilton
scoutii76
Thu Nov 8 21:05:48 UTC 2012
For my 7730/7749 I was just going to use the code 59But I also have projects with the electronic trans and it didn't look like the code 59/7730 was going to give me turbo and etrans control.So I picked the 7427.From: davida1 at hiwaay.net
To: gmecm at diy-efi.org
Date: Thu, 8 Nov 2012 14:26:57 -0600
Subject: Re: [Gmecm] PCM-6 Turbo
Robert, I would love to see this. I have an $A1 turbocharged car now. I
re-scaled it for 2-bar and it runs well, but yours sounds like a much better
solution!
Thanks,
David
----- Original Message -----
From:
Robert
Saar
To: gmecm at diy-efi.org
Sent: Wednesday, November 07, 2012 8:00
PM
Subject: Re: [Gmecm] PCM-6 Turbo
assuming nobody else has, i wouldn't mind sharing the patch i made
for nAst1 to allow up to 3BAR support. you may have to do some digging
to find where to apply the jump/return locations, but otherwise it's
been bench-tested.
the way i have it setup now, it accounts for fuel via a 2d table
with 10kPa increments to 300kPa as a BPW mulitplier. for spark, i just
have a basic "retard vs kPa" table that runs from 100 to
300kPa.
--- On Wed, 11/7/12, Bill Hamilton
<scoutii76 at hotmail.com> wrote:
From:
Bill Hamilton <scoutii76 at hotmail.com>
Subject: [Gmecm] PCM-6
Turbo
To: "gm ecm" <gmecm at diy-efi.org>
Date: Wednesday,
November 7, 2012, 8:15 PM
Anyone played with the code for the PCM-6/7427/8625
etc... to allow 2 or 3 bar map for turbo application?
I'm
running the $0E with MPFI and the 4l80E but thinking of adding a
turbo.
I've seen the WB code but haven't seen anyone mention
turbo/supercharger addition.
Thanks,
Bill
USN-1
-----Inline Attachment
Follows-----
_______________________________________________
Gmecm
mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm
_______________________________________________
Gmecm mailing
list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/gmecm/attachments/20121108/1e214e22/attachment.html
More information about the Gmecm
mailing list