[Wbo2] Can't get up and running

[Russ Hildebrand]

Hi All:

I have the kit all assembled and have successfully run through the test 
procedures. Everything's fine until I attach the sensor, then no LED comes 
on. I have 12.6 volts at the htr + connection J3

 I have the L2H2 sensor so I have the following setup:

 Heater circuit
J2 - yellow to sensor
J1 - blue to sensor - 10.35 volts

UEGO
J7 - black - 3.99v
J6 - White - 3.91v
J5 - Red - 5.91v

The crossover info I was given for the Honda sensor v the L2H2 wiring is

connection	Honda	L2H2
	J2	yellow	yellow
	J1	orange	blue
	J7	black	black
	J6	white	white
	J5	red	red

Any ideas what might be keeping the system from heating up? I'm a real 
rookie at this stuff, so your help is sure appreciated.

Thanks,

Russ Hildebrand