[Wbo2] Can't get up and running

[Tim Marsteiner]

What regulator do you have?

The LT1086 requires a 12.7 v input (J3) while the
LM317 requires 13.5 v input(J3).

The 10.35 might be just a shade too low to turn on the
LED.


Tim


--- Russ Hildebrand <russellh911 at comcast.net> wrote:

> Hi All:
> 
> I have the kit all assembled and have successfully
> run through the test 
> procedures. Everything's fine until I attach the
> sensor, then no LED comes 
> on. I have 12.6 volts at the htr + connection J3
> 
>  I have the L2H2 sensor so I have the following
> setup:
> 
>  Heater circuit
> J2 - yellow to sensor
> J1 - blue to sensor - 10.35 volts
> 
> UEGO
> J7 - black - 3.99v
> J6 - White - 3.91v
> J5 - Red - 5.91v
> 
> The crossover info I was given for the Honda sensor
> v the L2H2 wiring is
> 
> connection	Honda	L2H2
> 	J2	yellow	yellow
> 	J1	orange	blue
> 	J7	black	black
> 	J6	white	white
> 	J5	red	red
> 
> Any ideas what might be keeping the system from
> heating up? I'm a real 
> rookie at this stuff, so your help is sure
> appreciated.
> 
> Thanks,
> 
> Russ Hildebrand
> 
> _______________________________________________
> Wbo2 mailing list
> Wbo2 at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/wbo2
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com