J-bodies and MAP vs MAF

[Clare Snyder]

Bruce Plecan wrote:
> 
> -----Original Message-----
> From: Clare Snyder <snyder at huron.net>
> To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
> Date: Friday, April 17, 1998 9:22 PM
> Subject: Re: J-bodies and MAP vs MAF
> 
> >TBK wrote:
> >> Mass systems had map too. Therefore on the Mass needs to be added. The
> EGR
> >> (digital or linear) may be different. HEI or DIS is slightly different.
> 
> >> Subject: J-bodies and MAP vs MAF
> 
> .  According to the schematics I've seen, some are MAF and
>  some are MAP based on different years and\or models.  The manuals I have
> only go up to '90, however.
> >> > Does anyone know if any J-bodies are MAP based, and what years or
> models?
> >> >Adam
> >> >
> >There were so many problems with the MASS sensors that GM developed the
> >speed-density prom rather than replace the mass sensors. Many vehicles
> >with the mass installed don't use it at all. Eventually they stopped
> >installing it.
> >--
> You wouldn't happen to have a TSB number on when they were doing this would
> you?.  Or a part no for the wire update/prom part no.
> would you?.
> TIA
> Bruce
No wire update. Just the prom. I don't have thetsb available - might be
able to dig it up next week when I can get to my brother's Mitchel On
Demand system
-- 
                               _/\_
                       --|-----([])-----|--
                         S    0/  \0    B
         Alls well that ends well!! www.snyder.on.ca is back
                  E-Mail service is back to normal
                  To avoid bouncing E-Mail messages
                    Reply to Clare at snyder.on.ca
                                OR
Remove the R from clsnyder in my E-Mail Address to reply. Stop the
spammers!!!
It's hard to soar like an eagle when your stuck with a bunch of
Turkeys!!!